TRC:Code for gear units series

        1).no code means foot-mounted
        2).F: B5 flange mounted
        3).Z: B14 flange mounted
        4).X: single-stage foot-mounted
        5). XF: single-stage flange-mounted

        specification code of gear units 01,02,03,04

        1) no code means foot-mounted, no flange
        2) I,II,III: B5 output flange specification, default I not to write out is ok
      

        1). IEC:motor adapters
        2). HS: Shaft input

      Transmission ratio of gear units i

        M1:mounting position, default mounting position M1 not to write out is ok

        Position diagram for motor terminal box default position 0° (R) not to write out is ok

        1).No mark means without motor
        2).Model moto(poles of power)

        Voltage -frequency

        Position diagram for motor terminal box default position 1 not to write out is ok